Interlogix Concord Express User Manual - Manual (Page 17)

Concord Express User Instructions 11
5. If leaving the premises, exit through a designated delay door immediately.
Arming Level 3
—AWAY
At other times, you want every sensor to be alert: When the family is away from
home, or, in a business, after closing time.
In this and similar situations, set your system to 3—AWAY for maximum
protection. All sensors are active—perimeter door and window sensors, and
interior motion detectors.
To arm to Level 3
—AWAY using a touchpad:
1. Close all perimeter doors and windows.
2. Press 3 at any touchpad. Touchpads display, “Enter Code.”
3. Enter your access code. Touchpads display, “Armed to AWAY.”
4. The system sounds three short beeps. ARMED indicators on fixed display
touchpads will light (indicator will flash during the exit delay). The exit beeps
begin.
5. Exit through a designated delay door immediately.
Keychain Touchpad Arming
To disarm your system with a keychain touchpad, press the Unlock button.
Your installer can set up your keychain touchpad to arm the system in one of two
ways:
• Press the Lock button to arm the system directly to Level 3 with no Exit delay.
Using this method, you would not be able to arm to Level 2.
• Press the Lock button to increase the arming level each time it is pressed
(Level 1 to Level 2, or Level 2 to Level 3). The Exit delay time would be
applied.
Note
: Your system may be configured to sound short beeps on exterior sirens
when arming or disarming the system using a keychain or wireless touchpad.
This gives confirmation that an arming change was successful even when
outside. Ask your installer about this feature.
Quick Arm
Your system may be set up so that you’re able to arm the system without using
an access code.