Interlogix Concord Express User Manual - Manual (Page 41)

Concord Express User Instructions 35
• If the phone test is unsuccessful, the touchpad displays “SYSTEM PHONE
TEST ALARM,” then, “MEMORY,” and finally, “PHONE FAILURE ALARM
MEMORY.”
If a phone test is unsuccessful, check to see if you hear a dial tone from phones
in the house. Call your dealer if you hear a dial tone, but your phone test is
unsuccessful.
Testing Sirens
The purpose of this weekly test is to verify that the panel is activating sirens with
the appropriate warning sounds.
To perform an alarm siren warning sound test:
1. Contact the central monitoring station to inform them that you will be
activating alarms and they should not dispatch authorities.
2. Activate alarms of each type (fire, police, auxiliary), one at a time.
3. Listen for the appropriate siren sound when each alarm is activated (see the
“System Alarm Sounds” on page 20.
4. Contact the central monitoring station to inform them that you are finished
activating alarms.
Table 3: Testing sensors and zones
Device Test procedure Touchpad result
Touchpads Send a:
• Police panic alarm,
• Fire panic alarm, and
• Auxiliary panic alarm.
• Touchpad Panic POLICE
OK
• Touchpad Panic FIRE
OK
• Touchpad Panic
AUXILIARY OK
• POLICE PANIC OK
• FIRE PANIC OK
• AUXILIARY PANIC OK
Wireless Touchpads Press the Bypass key.
• Zones nn OK
• SENSOR nn OK
OR
•
Touchpad Panic POLICE
OK
• POLICE PANIC OK
Panic buttons Press and hold the appropriate
panic button(s) for 3 full
seconds.
• Zones nn OK
• SENSOR nn OK