Interlogix Concord Express User Manual - Manual (Page 44)

38 Concord Express User Instructions
Table 4: Causes of trouble beeps
Touchpad feedback
after pressing * Trouble condition
AC POWER FAILURE The panel power transformer may be unplugged or there may be an
AC power outage. If the transformer is plugged in, check the circuit
breaker or fuse that controls that outlet.
The backup battery will take over, but if AC power is not restored
within 15 minutes, the system will alert you and the central monitoring
station (if your system is monitored). It reports again when power is
restored.
LOW BATT The power in the emergency backup battery is low and must be
recharged or replaced. If AC power is out, the security system may
shut down once the battery is below the operating level. When AC
power is restored, the panel will recharge the battery. If the trouble
condition exists more than 24 hours after AC power is restored, call
your security dealer for service.
SENSOR
SUPERVISORY There is a problem with how the sensor is communicating with the
panel.
1. Test the sensor as described in “Sensor Test.”
2. If the sensor does not test OK, call your security dealer for
service.
SENSOR TROUBLE A sensor may have an internal problem or a fire/smoke sensor may
not have properly reset after activation, or the sensing chamber may
be dirty or partially obstructed.
1. Test the sensor as described in “Sensor Test.”
2. If testing the sensor does not clear the trouble condition, call your
security dealer for service.
SENSOR XX LOW
BATTERY A sensor has a low battery.
1. Disarm the system.
2. Remove the sensor cover. If the battery is an Alkaline AAA or AA,
change the battery(s). If the battery is any other type, call your
security dealer for service.
SENSOR XX TAMPER A sensor cover is off or open. Secure the cover and trip the sensor to
clear the tamper condition.