Interlogix Concord Express User Manual - Manual (Page 43)

Concord Express User Instructions 37
Silencing Trouble Beeps
If possible, correct the situation which is causing the trouble beeps. If this is not
possible, call for service. If the problem is not corrected, trouble beeps and
messages start again 4 to 10 hours later.
To stop trouble beeps:
1. Perform a system status check by pressing Ç on a touchpad,
2. Change the arming level.
Table 4 on page 38 describes the conditions under which trouble beeps occur
and when they begin. (These sounds are heard from interior sirens and
touchpads if available.)
Frequently Asked Questions
Q> I can’t arm my system.
A> Try the following:
• If arming to Level 2—STAY or Level 3—AWAY, make sure all monitored
perimeter doors and windows are closed.
• Press * for a system status and for clues to the problem.
• Call your security dealer.
Q> I cannot bypass a sensor: my alphanumeric touchpad displays “INVALID” and
my fixed display touchpad sounds a single, long beep.
A> Possible explanations include:
• The sensor you’re trying to bypass may not be active in the current arming
level. For example, an interior motion detector will not be active in Level 2—
STAY.
• Some sensors can be bypassed only in certain levels. For example, motion
sensors in Level 3—AWAY.
• You may be trying to bypass a 24-hour sensor than cannot be bypassed,
such as a smoke detector.
Q> I can’t arm my system to Level 3—AWAY.
A> If a delay door is opened while you’re trying to arm the system to Level 3, the
system will arm to Level 2 instead. Close the delay door, arm the system to Level
3, then exit through a delay door.