Interlogix Concord Express User Manual - Manual (Page 24)

18 Concord Express User Instructions
Bypassing a Sensor Directly
Use this method if the system is armed and you would like to open a window
without disarming.
Refer to the Appendix A User Sheets to determine what the sensor number is for
the sensor you wish to bypass.
To bypass sensors directly:
1. Close all doors and windows.
2. Arm your system to the desired level.
3. At any touchpad, press # (labeled Bypass) + Code + sensor number.
4. Touchpads display, “Bypassed Zones 01,” or “SENSOR 01 BYPASSED,” for
example.
If the touchpad displays “INVALID,” or if the touchpad sounds one long beep,
make sure that you entered a valid access code and a valid sensor number.
Gas, heat, and smoke sensors cannot be bypassed.
5. Bypass other sensors, if necessary, by repeating Step 3.
6. The bypassed door or window can now be opened.
To arm bypassed sensors:
Arm the system again.
OR
At any touchpad, press # (labeled Bypass) + Code + sensor number.
Note
: You cannot bypass sensors directly using a keychain touchpad.
Touchpads display, “Zones 01 OK,” or “SENSOR 01 UNBYPASSED,” for
example.
If the touchpad displays “INVALID,” or if the touchpad sounds one long beep,
make sure that you entered a valid access code and a valid sensor number.
Bypassing a Sensor Indirectly
Use this method if you are arming the system and would like to bypass doors and
windows already open.
To bypass sensors indirectly:
1. Leave open only those doors and windows that are to remain open. Close all
others.