Interlogix Concord Express User Manual - Manual (Page 33)

Concord Express User Instructions 27
To enable Arming Always Silent:
Note
: Exit Delay is doubled when you enable Silent Arming.
1. Enter the programming menus by pressing 9 + System Master Code.
2. Press 2 + 1 .
3. To turn Silent Arming:
on, press 2 + #. No system status beeps will sound while arming.
off, press 1 + #. System status beeps will sound from touchpad while arming.
4. Press * + 4 + # to exit the programming menus.
Adjusting the Touchpad Beeps
The frequency or pitch of chime and trouble beeps from each fixed display
touchpad can be adjusted individually to a more desirable or distinct tone.
Chime and trouble beep tones sound using the default frequency during, or
within 15 seconds of, any button activity at that specific touchpad.
To change status tone pitch:
1. Press and hold the * and 0 until you hear a steady tone, then release the
buttons.
2. Press and hold 1 to lower the pitch or press and hold 2 to raise the pitch.
3. Release the button when the desired pitch is heard.
After about 10 seconds of no touchpad activity, the steady tone stops sounding.
Adjusting the Touchpad Display Brightness
You may want to change the brightness of a touchpad display based on its
location in a building or room. For example, dim the touchpad display in a
bedroom or enhance a display near a window.
Changing the touchpad display affects only the touchpad currently being used.
To change touchpad display brightness:
1. Enter the programming menus by pressing 9 + System Master Code.
2. Press 2 + 2 .
3. Select a brightness level:
0 + # Off
1 + # Low