Interlogix Concord Express User Manual - Manual (Page 18)

12 Concord Express User Instructions
To use Quick Arm:
• Increase the arming level by simply pressing 2 or 3 at any touchpad.
• Decreasing the arming level requires that the user enter a code.
Quick Exit
Note
: In UL Listed systems, this feature is disabled.
Your system may be set up so that when your system is armed to Level 2—
STAY, you’re able to press D on any touchpad and simply walk out of the door
without having to disarm and rearm the system.
This is useful when your system is armed and you want to quickly pop outside to
pick up the newspaper without disarming your system.
Important: If you step outside and are planning to come back in, do not close the
door behind you!
To use Quick Exit:
1. When the system is armed to 2—STAY, press D at any touchpad. You will
begin to hear one beep every five seconds. These beeps will continue
throughout the 2 minute Quick Exit interval.
Note
: Opening the door without pressing D will cause the entry delay to
begin.
2. Open the door and go outside. Leave the door open if you are planning to
come back in!
3. Come back in within two minutes and close the door. The system will rearm to
2—STAY.
Using the Chime Feature
Turning on the Chime feature is like having bells on every protected door and
window. When this feature is on, sirens and speakers sound 2 beeps whenever
anyone opens a protected door or window.
The Chime feature works only in Level 1—OFF.
To turn Chime on/off:
While in Level 1—OFF, from any touchpad, press 7 + 1. While the Chime feature
is on, touchpads display, “CHIME IS ON” or “Chime.”
When the system is armed again, Chime becomes deactivated.