Interlogix Concord Express User Manual - Manual (Page 22)

16 Concord Express User Instructions
Extended Delay
In some situations, additional time is needed to arm or disarm the system from,
for example, a protected outside gate or door. In these instances, the installer
can program an extended delay, giving as much as 16 minutes to exit or disarm
the system before setting off an alarm.
Refer to the Appendix A User Sheets, “Delay Doors and Delay Time Settings,”
for a list of actual exit delay times.
Exit Extension
Note
: In UL Listed systems, this feature is disabled.
Your system may be set up so that the exit delay time is restarted if you reopen
the delay door during the initial exit delay time.
This is useful if, after arming the system, you walk out the door, then remember
something you forgot inside. You can reenter and exit through the delay door
without disarming and rearming the system.
Note: The Exit Extension will work on the first re-entry only.
If your system is not using this feature, you must disarm the system when you
reenter the armed premises to avoid setting off an alarm.
No Delay
—For Instant Alarm
You can choose to turn off the Entry and Exit Delays, causing the delay doors to
arm immediately. Anyone entering the house through the delay door when the
system is set to No Delay would immediately cause an alarm.
No Delay is normally used:
• When you’re staying at home, after you’ve armed the system.
• When you’re arming and disarming your house from the outside. (You must
have a wireless touchpad in order to do this.)
Arming to Level 2 or 3 with No Delay:
1. Close all perimeter doors and windows.
2. Exit the premises if arming to Level 3—AWAY.
3. Enter: 2 + Code or 3 + Code .
The system sounds two or three short beeps.
4. Immediately after hearing the beeps, press 4 for No Delay.