Interlogix TruVision PTZ Mini 12X User Manual - Manual (Page 11)

1BChapter 2: Installation
TruVision Mini PTZ 12X Camera User Manual 7
Removing the protective cover from the outdoor
dome camera
The outdoor dome camera is shipped with a protective cover and PE sheet on the
dome camera for protection. These must be removed before installation.
To remove the protective cover and PE sheet
1. Unpack the dome camera.
2. Turn the dome camera upside down and
place it on the cushion. Then rotate the
outdoor top mount bracket counterclockwise
and detach it from the main dome camera
housing.
3. Remove the protective cover and PE sheet
from the dome camera.
4. Use an applicator brush and smear some
lubricant on the surface of the bubble
waterproof rubber gasket.
Then attach the bubble to the dome camera
body by first aligning the center point on the
cover with one of the four holes on the dome
camera housing, as shown.
5. Using both hands on either side of the
bubble, gently press down the bubble. Make
sure the two slotted screws and the screw
hole on the bubble align with the three holes
on the dome camera housing.