Interlogix TruVision PTZ Mini 12X User Manual - Manual (Page 38)

3BChapter 4: Basic setup
34 TruVision Mini PTZ 12X Camera User Manual
Auto return settings
Set the dome camera to automatically return after a period of inactivity to a specific
preprogrammed preset, preset tour, autopan, or shadow tour position. This feature is
disabled by default.
This function is located on Main Page 2.
Figure 19: Auto Return screen (screen for Preset mode shown)
Table 16: Auto Return menu description
Function Description
Auto Return Enable or disable the function.
Return Action This function tells the camera which mode to execute when auto return
is enabled and the set return time is reached.
Select one of the four following modes: Autopan, Preset Tour, Shadow
Tour, and Preset. Depending on which mode is selected, the menu item
below changes.
Preset This is listed if Preset was selected as the return action mode (see
Figure 19 above.)
Select a preprogrammed preset point to where the camera should
return when the return time is activated. See “Preset ” on page 29 for
more information.
Preset Tour This is listed if Preset Tour was selected as the return action mode.
Select a preset tour that the camera should execute after a period of
inactivity. See “To set a preset point” on page 29” for more information.
Autopan This is listed if Autopan was selected as the return action mode.
Select a preprogrammed autopan that the camera should execute after
a period of inactivity. See “Autopan ” on page 31 for more information.
Shadow Tour This is listed if Shadow Tour was selected as the return action mode.
Select a preprogrammed shadow tour that the camera should execute
after a period of inactivity. See “Shadow tour ” on page 32 for more
information.
Return time Select the period of inactivity (return time) after which the auto return is
activated. The time period ranges between 1 and 128 minutes.
Go If Auto Return has been enabled, you can execute an auto return
manually.
Exit Select Yes to save any changes and return to Main Page 2.