Interlogix TruVision PTZ Mini 12X User Manual - Manual (Page 47)

4BChapter 5: Advanced setup
TruVision Mini PTZ 12X Camera User Manual 43
Table 23: Day/night menu description
Function Description
Auto Select this option for day/night mode to be automatically activated. The
internal circuit will automatically decide the threshold to remove the IR
cut filter according to the value of light condition calculated by internal
light algorithms. The options include Low, Mid, and Hi.
Low indicates a higher sensitivity and can improve reliability of lens so
that it is fast to switch to Day mode and relatively difficult to change into
Night mode; Hi indicates that it is fast to switch to Night mode and
difficult to change into Day mode.
This is the default setting.
Manual Select manually whether day or night mode is activated.
Select On to deactivate the IR cut filter and put the camera in B/W (Night)
mode. Select Off to activate the IR cut filter and put the camera in color
(Day) mode.
Exit Select Yes to save any changes and return to Main Page 3.
Alarm settings
You can program actions for alarms. The camera has eight alarm inputs and one
alarm output (NO and NC) to which to connect alarm devices.
Figure 23: Alarm setting menu
Table 24: Alarm setting menu description
Function Description
Alarm Enable or disable this option. The default setting is Off.
Alarm Contact Select a number for the alarm contact being setup. For alarm
contact definitions, please refer to “22-pin connector description”
on page 14. Up to eight alarm contacts can be set.
Note: If two or more alarm contacts are triggered at the same
time, the lower alarm contact number will have priority. For
example, if Alarm 1 and Alarm 3 are triggered simultaneously,
only Alarm 1 will be handled.
Contact Type Select the contact type (NO, NC).