Interlogix TruVision PTZ Mini 12X User Manual - Manual (Page 35)

3BChapter 4: Basic setup
TruVision Mini PTZ 12X Camera User Manual 31
Function Description
Dwell Time Set the period of time that the camera will stay at a preset tour step. The
range is from 0 to 127 seconds. The camera will move to the next preset
tour step when the dwell time expires. If the setting is 0, the dome will stay
at this preset your step until the camera is manually moved.
Run P Tour Manually select which P Tour to view after programming.
Exit Select Yes to save any changes and return to Main Page 2.
Autopan settings
The autopan feature allows the dome camera to pan continuously between right and
left limit settings. An autopan movement requires the start and end points to be
defined as well as specifying whether the movement is clockwise or
counterclockwise.
This function is located on Main Page 2.
Figure 17: Autopan menu
Table 14: Autopan menu description
Function Description
Autopan You can set up to four autopan functions. Use the LEFT/RIGHT direction
keys on the keypad to choose a line to execute.
You can also have the camera to do endless panning by setting the
start point the same as the end point.
Start point To set the start position of the autopan path, proceed as follows:
1. While the menu option To Find is flashing, move the cursor to Start
Point and press set. The option will then become To Save.
2. Move the dome to the desired position and press set to save the
position as the start point. The cursor will move to End Point
automatically. Set the end point to complete the autopan setting.
Note: The tilt and zoom values of the start point are recorded and fixed
for the selected autopan.
End Point Set the end position of the P Tour. See “Start Point” above for further
information.