Interlogix TruVision PTZ Mini 12X User Manual - Manual (Page 23)

1BChapter 2: Installation
TruVision Mini PTZ 12X Camera User Manual 19
 M5 standard/security screws
C. Screws and screw anchors for fixing the standard pendent mount onto the wall
(not included)
Tools needed
 Tool for drilling
 Tool for screwing
To pendant mount the dome camera
1. Drill a cable-access hole in the wall where you want to install the pendant mount.
2. Using the correct screws and screw anchors, fix the pendant mount to the wall.
Figure 10: Pendant-mount
Standard pendant mount Extended pendant mount
1. Pendant-mount
2. Waterproof rubber boot
3. Cover of the outdoor mounting kit
4. 22-pin connector is at the end of the I/O interface
cable
5. Screws and screw anchors to attach pendant mount
to wall
6. Screws and washers to attach pendant mount to the
outdoor mounting kit
3. Attach the waterproof rubber boot to the pendant mount.
4. Run the cable through the pendant mount. The 22-pin connector of the I/O
interface cable should exit from the pendant mount.
Note: Block the cable-entry hole in the wall with the supplied sponges to prevent
insects from entering the pendant mount.
5. Thread the cables through outdoor mount kit.