Interlogix TruVision Intelligent IP Dome Configuration Manual User Manual
Page 23
TruVision 12/32 Series IP Camera Configuration Manual
21
Parameter
Description
mode according to the configured time period.
Triggered by Alarm Input: The camera switches to the day mode or the
night mode after the alarm is triggered.
Sensitivity
If you choose Auto Day/Night switch, you can choose the sensitivity
value from 0 to 7. The higher the value, the easier it is for the mode to
switch. Default is 4.
Filtering Time
Only available when Auto D/N switch mode is selected. The filtering time
refers to the interval time between the day/night switch. You can set it
between 5 and 120 s.
Smart IR
When enabled, it can avoid over exposure issue. Default is OFF.
IR Light
Select ON/OFF to Enable/disable IR. Default is OFF.
Enable: the IR illuminators will be ON, when the camera turns into night
mode.
Disable: the IR illuminators will be OFF, when the camera turns into
night mode
Note: The IR illuminators always are OFF in Daytime mode.
5. Backlight Settings
BLC Area
If you focus on an object against strong backlight, the object will be too
dark to be seen clearly. BLC compensates light to the object in the front
to make it clear. OFF, Up, Down, Left, Right, and Center are selectable.
WDR
When enabled, this feature (wide dynamic range) allows you to see
details of objects in shadows or details of objects in bright areas of
frames that have high contrast between light and dark areas. Default is
OFF.
6. White Balance
White Balance
White balance (WB) tells the camera what the color white looks like.
Based on this information, the camera will then continue to display all
colors correctly even when the color temperature of the scene changes
such as from daylight to fluorescent lighting, for example. Select one of
the options:
AWB1: Apply for small range of 2500 to 9500K
,
for environments where
the lighting is always stable.
AWB2: Apply for large range of 2200 to 15000K,
for environments
where there is variation in the lighting. For example, in a room that has
daylight and fluorescent lighting.
MWB: Manually adjust the color temperature to meet your own
requirements.
Locked WB: Locks the WB to the current environment color
temperature.
Incandescent Lamp: For use with incandescent lighting.
Warm Light Lamp: For use where the indoor light is warm.
Natural Light: For use with natural light.
Fluorescent Lamp: For use where there are fluorescent lamps installed
near the camera.
7. Image Enhancement
Digital Noise Reduction
Digital noise reduction (DNR) reduces noise, especially in low light
conditions, to improve image performance.
Options include: Normal Mode, Expert Mode, or OFF. Default is Normal.