Interlogix TruVision Intelligent IP Dome Configuration Manual - Manual (Page 53)

TruVision 12/32 Series IP Camera Configuration Manual 51
If you have selected “All day”, select one of the record types to record from the drop-
down list box:
• Continuous: This is continuous recording.
• Motion detection: Video is recorded when the motion is detected.
• Alarm: Video is recorded when the alarm is triggered via the external alarm
input.
• Motion | Alarm: Video is recorded when the external alarm is triggered or
motion is detected.
• Motion & Alarm: Video is recorded when motion and alarms are triggered at the
same time.
• Face Detection: Video is recorded when a face is detected. See “Face
detection” on page 35 for more information.
• Cross line: Video is recorded when the pre-defined line on-screen in crossed.
See “Cross line detection” on page 39 for more information.
• Intrusion Detection: Video is recorded when an intrusion is detected. See
“Intrusion detection” on page 41 for more information.
• Scene Change detection: Video is recorded when a change in the camera
scene is detected. See “Scene change detection” on page 44 for more
information.
5. If you enable “Customize”, click the day of the week required. For period 1, set the
start and end times during which you want the camera to begin and end recording.
From the drop-down list box, select one of the record types to record (see the list
above).
Repeat for additional periods in the day. Up to eight time periods can be selected.
Note: The eight time periods cannot overlap.
6. Set the recording periods for the other days of the week if required.
Click Copy to copy the recording periods to another day of the week.
7. Click OK and Save to save changes.
Note: If you set the record type to “Motion detection” or “Alarm”, you must also define
the arming schedule in order to trigger motion detection or alarm input recording.
RS-232 settings
The RS-232 port can be used in two ways:
• Console: Connect a computer to the camera through the serial port. Device
parameters can be configured by using software such as HyperTerminal. The serial
port parameters must be the same as the serial port parameters of the camera.
• Transparent channel: Connect a serial device directly to the camera. The serial
device will be controlled remotely by the computer through the network.