Interlogix TruVision Intelligent IP Dome Configuration Manual User Manual
Page 38
36
TruVision 12/32 Series IP Camera Configuration Manual
Figure 13: Face detection window
To define face detection:
1. From the menu toolbar, click
Configuration
>
Events
>
Face Detection
.
2. Check
Enable Face Detection
to enable the function.
3. Check
Enable Dynamic Analysis
for
Face Detection
if you want the face detected
to be marked with a green rectangle in live view.
Note: If you do not want the detected face marked with the green frame, select
Disable
from Configuration > Local Configuration > Live View Parameters > Rules.
4. Configure the sensitivity of the face detection. The range is between 1 and 5.
5. Click
Edit
to set the arming schedule for the alarm input. See “Motion detection
alarms” on page 26 for more information.
6. Specify the linkage method when an event occurs. Check one or more response
methods for the system when a face detection alarm is triggered.