Interlogix TruVision Intelligent IP Dome Configuration Manual - Manual (Page 59)

TruVision 12/32 Series IP Camera Configuration Manual 57
Defining the security service
This function enables Telnet and let you define its password. It is only used by
Technical Support.
Figure 24: Security service window
To define Telnet:
1. From the menu toolbar, click Configuration > Security > Security Service .
2. Check the checkbox of Enable Telnet .
3. Click Save to save the changes.
Note:
1. The Telnet user name is root as default and cannot be changed.
2. The default Telnet password is “ab12!”
3. The password should have least four characters with at least one letter and one
number.
Restore default settings
Use the Default menu to restore default settings to the camera. There are two options
available:
 Restore: Restore all the parameters, except the IP parameters, to the default
settings.
 Default: Restore all the parameters to the default settings.
Note: If the video standard is changed, it will not be restored to its original setting when
Restore or Default is used.
To restore default settings:
1. From the menu toolbar, click Configuration > Security > Maintenance .
2. Click either Restore or Default . A window showing user authentication appears.
3. Enter the admin password and click OK.