Interlogix TruVision Intelligent IP Dome Configuration Manual - Manual (Page 47)

TruVision 12/32 Series IP Camera Configuration Manual 45
Figure 17: Scene change detection window
To define scene change detection:
1. From the menu toolbar, click Configuration > Events > Scene Change Detection .
2. Check the Enable Scene Change Detection checkbox to enable the function.
3. Configure the sensitivity ranging from 1 to 100, the higher the sensitivity, the easier
the change of scene can trigger the alarm.
3. Click Edit to set the arming schedule for the alarm input. See “Motion detection
alarms” on page 26 for more information.
4. Specify the linkage method when an event occurs. Check one or more response
methods for the system when a scene change detection alarm is triggered.