Interlogix TruVision Intelligent IP Dome Configuration Manual - Manual (Page 54)

52 TruVision 12/32 Series IP Camera Configuration Manual
To set up the RS-232 settings:
1. From the menu toolbar, click Configuration > System > RS232 .
2. Select the RS-232 port parameters.
Note: If you want to connect the camera using the RS-232 port, the RS-232
parameters must be the same as those configured here.
3. Click Save to save changes.
RS-485 settings
The RS-485 serial port is used to control the PTZ of the camera or connect to light and
wiper devices. Configuration of these parameters should be done before you connect to
any devices.
Note: Only the box camera and VF mini dome support RS-485.
To set up RS-485 settings:
1. From the menu toolbar, click Configuration > System > RS485 .
2. Select the RS-485 port parameters.
Note: The Baud Rate, PTZ Protocol, and PTZ Address parameters should be
exactly the same as the PTZ camera parameters.
3. Click Save to save changes.