Interlogix TruVision Intelligent IP Dome Configuration Manual - Manual (Page 32)

30 TruVision 12/32 Series IP Camera Configuration Manual
4. Under Switch Day and Night Settings , select OFF, Auto-switch or Scheduled-
switch. Default is OFF.
Auto-switch and Scheduled-switch allow you to set different settings for day and
night as well as different periods.
5. Select Area No. and click Draw Area . Click and drag the mouse on the live video
image to draw an area sensitive to motion detection.
Note: You can draw up to eight motion detection areas on the same image.
6. Click Stop Drawing to finish drawing. Click Clear All to delete all areas marked and
restart drawing.
7. Move the Sensitivity slider to set the sensitivity of the detection for the selected
areas.
8. Move the Proportion of Object on Area slider to set the proportion of the object
that must occupy the defined area to trigger an alarm.
9. Click Save to save the changes for that area.
10. Repeat steps 7 to 9 for each area to be defined.
11. Click Edit to edit the arming schedule. See the picture below for the editing interface
of the arming schedule.