Corinex Global ADSL2+ - Manual (Page 111)

7. Can you PING the WAN IP? Your ISP should have provided the IP address of their
server. If you can ping the Gateway and your protocols are configured correctly,
you should be able to ping the ISPs network. If you cannot PING the ISPs
network, make sure you are using the correct protocols with the correct VPI
VCI values.
8. Make sure NAT is enabled for your connection. If NAT is disabled the Gateway
will not route frames correctly (except in Bridge connection).
I can’t connect to the Gateway.
1. Check that the Power LED is green and that the network cables are installed
correctly; see the easy start guide for more details.
2. Make sure that your PC and the Gateway is on the same network segment. The
Gateway’s default IP address is 192.168.1.1 . If you are running a Windows based
PC, you can open a DOS window and type IPCONFIG; make sure that the
network adapter that is connected to the gateway is within the same 192.168.1.x
subnet.
3. Also, your PC’s Subnet Mask should match the gateways subnet mask. The
gateway has a default subnet mask of 255.255.255.0.
4. If this still does not work, press the reset button for 10 seconds. This will place
the gateway into its factory default state. Go through the above procedure
again.
5. Make sure NAT is enabled for your connection. If NAT is disabled the Gateway
will not route frames correctly (except in Bridge connection).
The DSL Link LED continues to blink but does not go solid.
1. This means that the DSL line is trying to train but for some reason it cannot
establish a valid connection. The main cause of this is that you are too far away
from the central office. Contact your DSL service provider for further
assistance.
2. Verify that the phone line is connected directly to the wall and to the line input
on
the Gateway.
3. Make sure that for every parallel phone line connected to telephone or fax to
install with a micro filter.
Corinex ADSL2+ Wireless Gateway G
Appendices
110