Corinex Global ADSL2+ - Manual (Page 77)

76
Corinex ADSL+ Gateway G Configuration
Corinex ADSL2+ Wireless Gateway G
The User Interface for Bridge Filter allows you to enable/add/edit/delete the filter
rules. Up to 20 entries are supported.
Follow the steps below to enable and configure Bridge Filters.
1. Check Enable Bridge Filters.
2. To add a rule, enter source MAC address, destination MAC address and frame
type with desired filtering type, and click Add. You can also edit a rule that you
created using the Edit checkbox. You can delete a rule using Delete.
3. Click Apply.
Note: There are three hidden filter rules within the bridge filter table. These
rules are entered automatically by the system to ensure the user does not
“lock” themselves out of the system. The first rule allows any and all ARP frames
through the system. The second rule allows all IPv4 frames with the destination
MAC address of the bridge to go through. The third rule allows all IPv4 frames
with the source MAC address of the bridge to go through.
Please find the description of the options in this page, in the table below.