Corinex Global ADSL2+ - Manual (Page 90)

Field Value
Frag Threshold In case of interference in the wireless channel,
or weak coverage, the Corinex ADSL2+ Wireless
Gateway G can fragment frames to optimize
performance. It will divide the frames into smaller
pieces and send them separately to the recipient.
Only data packets are fragmented, the broadcast
and multicast packets are transmitted unchanged.
The threshold value means the maximum size of an
unfragmented packet. Any frame larger than that
threshold will be fragmented. If there are no packet
losses in the wireless media, the value should be
unchanged. If you experience collisions, try to lower
the threshold to approx. 1000 bytes. If the network
performs well at this setting, you can try higher values
until you find the optimal performance.
The default value of the threshold is 2346 bytes.
Power Level You can choose the percentage of maximum power
output to meet your requirement. The default is
Full.
After the configuration, click on Apply. To enable the new settings you will have to
restart the access point. Please go to the System Commands section in the Tools
tab as shown below and click on Restart Access Point.
4.5.3 Security
In this section you can configure the security settings for the wireless access point.
After clicking on Security in the left menu, the following screen will appear.
89
Corinex ADSL2+ Wireless Gateway G Configuration
Corinex ADSL2+ Wireless Gateway G