Corinex Global ADSL2+ - Manual (Page 48)

47
Corinex ADSL2+ Wireless Gateway G Configuration
Corinex ADSL2+ Wireless Gateway G
4. Enter a unique name for the Bridge connection in the Name field.
The name must not have spaces and cannot begin with numbers.
5. Under Bridge Settings, select the encapsulation type (LLC or VC). Note: If you
are not sure just use the default mode.
6. Under PVC Settings, enter the values of VPI and VCI settings.
Note: Your DSL service provider or your ISP will supply these.
7. Select the quality of service (QOS); leave the default value if you are unsure or
the ISP did not provide this information.
8. Click the apply button to complete the connection setup. This will temporarily
save this connection.
9. To make the change permanent, click on Save all settings in the left menu.
10. For connection, click on Connect.
The Bridge Settings include the following options:
Field Description
Encapsulation The technique used by layered protocols in which a layer
adds header information to the protocol data unit (PDU)
from the layer above. As an example, in Internet termi-
nology, a packet would contain a header from the physical
layer, followed by a header from the network layer (IP),
followed by a header from the transport layer (TCP), fol-
lowed by the application protocol data. Two options are
provided: Logical Link Control (LLC) and Virtual Channel
(VC).
Select LAN There are three ethernet bridges you can select from.
The VLAN Settings include the options showed in following table:
Field Description
Sharing This is where you enable/disable sharing. The VLAN needs
to be selected to create VLAN.
VLAN ID VLAN Identification