Chatsworth Products RIM-600 - Manual (Page 24)

RIM-600 Manual
24 24
Figure 4: Wall-mounted Host Unit
Tabletop Installation
The RIM-600 Host can be installed on a tabletop or shelf. Follow the steps below:
1) Attach the four self-adhesive rubber feet to the four corners on the bottom of the RIM-600.
2) Place the unit on a tabletop or shelf and connect the power cord into a 90-260VAC outlet.
Figure 5: Tabletop-mounted Host Unit
Power On Self Test (POST)
When the power switch is turned on, the red and green input LEDs will begin a blinking pattern to
indicate that the unit is booting up and performing internal diagnostic tests. The unit will also beep
once, 25 seconds after power is applied. When the LEDs stop blinking, the unit is fully booted and
operational. The boot and Power On Self Test take approximately 2 minutes.
Connecting Sensors
The RIM-600 Host has eight sensor inputs. Each input can accept any sensor type. Sensors are
available to monitor the following:
n Temperature n Smoke
n Humidity n Security
n Water detection n Motion
n AC voltage
n Alarm contacts from external equipment
All RIM-600 sensors connect to the Host using standard RJ-45 cables. This makes it easy to con-
nect sensors directly to the unit. Simply plug one end of the cable into the sensor and the other end
into one of the sensor inputs on the Host.