Chatsworth Products RIM-600 - Manual (Page 42)

RIM-600 Manual
42
RIM-600 Host Identification message - Host Unit Properties Screen
RIM-600 Node Identification message - Node Unit Properties Screen
Input Sensor message
- Input Channel Setup Screen
IP Alarms message - IP Alarm Setup Screen
PowerGate messages - PowerGate Setup Screen
Software Installation and Hardware Requirements
This section describes how to install and configure the RIM-600 ConsoleView Software for your
enterprise.
Hardware and Software Requirements
Minimum Requirements:
Intel Pentium processor or equivalent
30 MB of free disk space
32 MB of RAM (64 MB RAM recommended)
Graphics card and monitor compatible with Microsoft Windows
® 95, 98, NT, 2000, or XP
Microsoft Windows ® 95, 98, NT, 2000, or XP
Mouse
Soundblaster-compatible sound card, microphone and speakers
Windows-compatible phone modem and/or RS-232 ports
Software Installation
The RIM-600 ConsoleView Software setup program makes installation quick and easy. Make sure
that all Windows applications are closed before attempting to run setup.
If you encounter problems during installation, please call CPI Technical Support at 800.834.4969.
Installing from the CD
1. Start Windows.
2. Insert RIM-600 CD-ROM
3. Select Start>Run and type in D:\Setup.exe and click OK.
Note: If your CD-ROM is installed on a drive letter other than D, substitute the appropriate
letter.
4. Follow the prompts until the installation is finished.
The RIM-600 ConsoleView Software for Windows will install to a directory named C:\Program
Files\RIM600, unless you choose to change the directory name. The installation program will give
you three installation choices: Typical, Compact, or Custom. For new installations choose Typical.
42