Chatsworth Products RIM-600 - Manual (Page 60)

RIM-600 Manual
60
Input/Alarm Classes
Classes are used to associate environmental inputs and IP alarms with people. Each input sensor
or IP address must be assigned to a Class. Each person or User Profile selects classes for which
they have responsibility. To view the list of Classes, expand the Settings menu, then right-click on
Classes and select Properties. Several classes have been pre-defined in the RIM-600 to give you a
starting point. The default Classes are:
• (Diagnostic)
• Temperature
• Humidity
• Water
• Power
• Other
• Smoke
• Security
• Backup Battery
• High Sound
• IP Alarms
Figure 29: Setup Classes
You can have up to 64 classes in the RIM-600. To add Classes, just type in a new class name in
the Class table list and click OK. The class programming screen is shown above. Note that the
Diagnostic Class does not appear in the list shown above. This is because it is a special case,
reserved for system faults, trouble alarms, and diagnostic alarms. The Diagnostic class cannot
be edited or deleted. Any user who wishes to receive these types of alarms should include the
Diagnostic class in their Profile Class list.
60