KERN & SOHN MLS 50-3C - Manual (Page 16)

16 MLS_C-BA-e-1330
6.3 Scope of delivery
Serial accessories:
• Moisture analyzer, see illustration chap. 2
• 10 sample dishes
• Power cable
• Operating manual
6.4 Mains connection
Power supply is provided via the supplied mains cable.
Check, whether the voltage acceptance on the scales is set correctly. Do not connect
the scales to the power grid unless the information on the scales (sticker) matches
the local mains voltage.
Important:
Does the labelling match the local mains voltage?
-
Do not connect if mains voltages are different!
-
If matching, connect the scales.
The moisture meter must be connected to a standard socket with earth terminal. Do
not eliminate the protective effect by using an extension lead without earth terminal.
For power supplies from power grids without earth terminals call a specialist to
establish equivalent protection according to the relevant installation regulations.
6.4.1 Switch on the unit
Press the
ON/OFF key. The unit will carry out a self-test. The device is ready for
measuring as soon as 0.000 g appears on the weighing display. If the display
deviates from zero, operate the
TARE key.
6.5 Connection of peripheral devices
Before connecting or disconnecting of additional devices (printer, PC) to the data
interface, always disconnect the balance from the power supply.
With your balance, only use accessories and peripheral devices by KERN, as they
are ideally tuned to your balance.
6.6 Initial Commissioning
In order to obtain exact results with the electronic balances, your balance must have
reached the operating temperature (see warming up time chap. 1).
During this warming up time the balance must be connected to the power supply
(mains, accumulator or battery).
The accuracy of the balance depends on the local acceleration of gravity.
Strictly observe hints in chapter Adjustment.