Leitz VariPlan Plus - Manual (Page 14)

D
eu
ts
ch
En
gl
is
h
日日
本本
語語
中
文
Ita
lia
no
Fr
an
ça
is
Es
pa
ño
l
Po
rt
ug
uê
s
Ру
сс
ки
й
14 04/2012 ID.524660 V1.0
Check the machine data, especially RPM and direction of rotation!
Danger of loosening of the tool.
Unproper stopping of the tool, e.g. by lateral pressing, is not allowed.
During mounting take care, that tool and all cutting and spare parts are mounted on
correct clamping devices.
Cutting parts shall not come in contact with clamping elements or machine parts.
When using stacked tooling ensure that the cutting parts are not in contact with each
other.
All clamping surfaces have to be free of dirt, grease, oil or water.
Tighten clamping screws and nuts by using appropriate mounting tool and the
recommended torque.
The extension of wrenches or the use of hammer blows is not permitted!
1.4.5 Precautions
Wear safety gloves!
Danger of injury by sharp cutting edges!
Wear ear protection!
Risk of becoming hard of hearing!
Check the cutting edges, clamping elements, screws and tool bodies regularly for
potential damages – especially after collision of the tool with parts of the machine e.g.
machine table, work piece clamping elements, dust hood.
Damaged or worn cutting parts, clamping elements or screws have to be set-wise
immediately replaced with original replacement parts.
Damaged tools have to be checked by an expert.
Danger of injuring from parts flying off.
Tools with cracked bodies or deformed seating of the cutting parts have to be taken out of
service. Repairing such tools is not allowed!