Leitz VariPlan Plus - Manual (Page 15)

D
eu
ts
ch
En
gl
is
h
日日
本本
語語
中
文
Ita
lia
no
Fr
an
ça
is
Es
pa
ño
l
Po
rt
ug
uê
s
Ру
сс
ки
й
15 04/2012 ID.524660 V1.0
Danger of tool breakage.
Do not use a deformed tool.
1.5 Cleaning and Maintenance
1 chip area
2 clearance face
For reasons of working safety, the cutting tip / cutting edges (see section “Servicing,
modifying, sharpening”) at the latest have to be serviced when:
- the wear mark width VB on the cutting edges amounts to more than 0,2 mm – pay
special attention to the main wear zones.
- break outs of the cutting edge are visible.
- the power consumption of the machine increases noticably.
Wear safety gloves!
Danger of injury by sharp cutting edges!
The cutting edges have to be regularly cleaned from resin and glue (built-up edges) – this
increases the performance time and the operational safety.
Protect hands and eyes while cleaning.
Detergents can irritate skin and eyes and damage the tool or clamping device.
Only use cleaning agents which do not corrode the tool materials, for example Sur-Tec 194
for steel only; Sur-Tec 143 or Avilub METACLEAN 788 for aluminium and steel.
The appropriate detergents and care products can be obtained from the tool manufacturer
Follow the instructions of the detergent manufacturer.