PRG Mbox Remote Manual 3.9 - Manual (Page 38)

32 MBOX ® REMOTE USER MANUAL
Warp mode is shown as a 3x3 array of rectangles, with all nine of the rectangles having a large, blue point. Warp
mode allows you to adjust the four corners by changing the position of the four corner points and to adjust the
intermediate curve using the other points. The warp is drawn as a Bezier curve between the corner points, using the
intermediate points as the third point on the curve.
CAUTION! Clicking on the Configure button and changing the output setup will reset all keystone/warp settings!
Note: Switching from one mode to the other will not affect the current settings, but if you switch from Warp mode to
Keystone mode and then adjust any point, the curves will revert to straight lines between the corner points.
You can apply a grid overlay for keystone and warp by setting the Master HUD parameter to a value of 221
and/or use the Grid Delay setting in the Output Setup. Refer back to
"Projection > Output Setup > Texture" on
page 29.
To reset the Output Setup, click on the Options pop-up above the column list of Identities and select the Clear
Output Settings option. This will remove all Texture, Vignette, and Keystone/Warp settings. If you intend to use
the Advance Projection Mode, you should clear the Output Setup first.