PRG Mbox Remote Manual 3.9 - Manual (Page 97)

MBOX ® REMOTE USER MANUAL 91
Parked Pixels
When editing a fixture or a profile, individual pixels included in the fixture can be "parked" at a specific (static) level so
as to override the RGB data that would be taken from the source, or to provide output levels for additional channels
that might otherwise sit at a level of 0. For example, setting static values for pan and tilt on moving light fixtures.
The park values are entered in the Pixels table at the right side of the Edit Fixture Profile window.
The syntax of the park value depends on the type of pixel. For example: 255, 0, 0 where R=255, G=0, and B=0. In this
case, the red value (255) would be represented by a red circle around the pixel in the previsualization view as shown
below. If the values are an override, they will be displayed in magenta text. If they are not an override, they will be
displayed in white text. (Refer to
"Previsualization" on page 83 for more information about the preview feature.)
Pixel Address
Pixel Type
Opens Type Popup
Park Values
Park Values (override)
Preview shows red ring