PRG Mbox Remote Manual 3.9 - Manual (Page 55)

MBOX ® REMOTE USER MANUAL 49
Enabling Mbox Pixel Mapping
To enable pixel mapping, the Pixel Map Enable checkbox must be checked in the Mbox Setup window. Checking this
box enables the processing of pixel mapping patches and the resulting output.
When Pixel Mapping is enabled in the Setup window, the Mbox Master Control parameter can be used to enable/
disable overall pixel mapping output, and to enable/disable the pixel mapping mask feature. Master Control
parameter settings are as follows:
+ 244 = enable pixel mapping output
+ 245 = disable pixel mapping output
+ 246 = disable mask feature
+ 247 = enable mask feature
Note: For more information about the Master fixture, refer to the appropriate Mbox software user manual (Designer,
Studio, or Mini).