Carrier Access CMG Router - Manual (Page 101)

CMG Router - Release 2.7 4-15
Profile Directory:Local Profile
Static Addresses
Static Addresses
Use this screen to define static addresses that are based on the Ethernet MAC or IP
Address of a specific device on the local LAN. Typically, the Adit would learn of these
devices by monitoring LAN/WAN packets. By defining a static address, you are telling
the Adit the location of the corresponding device before the Adit learns where this
device resides. Static addresses are typically used in a bridging situation.
Use the Local (LAN) Profile to define static addresses for devices that are located on
the LAN. If you wish to establish static addresses for devices on remote LAN’s, access
this screen using the corresponding Remote Profile.
Each static address filter will count toward the maximum number of 500 filters.
1. Select Configuration <Profile Directory> on the Main menu, and select
[E NTER ].
2. Select LAN <Setup -> and select [E
NTER
].
Profile
Directory
Window