Defining protocol filters, Defining protocol filters -23 – Carrier Access CMG Router User Manual
Page 109
CMG Router - Release 2.7
4-23
Profile Directory:Local Profile
Filters
Defining Protocol Filters
Use this screen to define filters that are based on specific protocols being used by LAN
devices. These filters, when enabled, provide security by restricting LAN/WAN access
based on a specific protocol.
Protocol Name - Filter name can be up to 7 characters.
Ethernet Value - Enter the assigned Ethernet value for this protocol, see Addendum B,
Ethernet Protocol Types.
IEEE Value - Enter assigned IEEE value for this protocol. The IEEE value is the same
as the DSAP and SSAP values in a SNAP packet.
NOTE: Only identify either an Ethernet or IEEE value, but not both.
To enable a filter return to the Enabled Filter Window ([E
SC
] from this window) and
select [C
TRL
A], select filter type (Custom, Protocol or Address) filter will be added to
the Enabled Filters window.
NOTE: Each filter, even if it is not enabled, will count toward the maximum
number of 500 filters.
Protocol
Filter
Window