Carrier Access CMG Router - Manual (Page 73)

CMG Router - Release 2.7 3-35
Profile Directory:Router Card Profile
MGCP
Quarantine Notification Handling
<Loop> Can generate multiple notifications to a request notify.
<Step> Generate at most one notification to a request notify (default).
Quarantine Event Handling
<Discard> Discard events that are in the quarantine buffer.
<Process> Process events that are in the quarantine buffer (default).
RSIP Wildcard
<Disabled> Allows interoperability with call agents that require RSIPs to be channel specific.
<Enabled> Enable interoperability with call agents that require the RSIP by issuing a single wildcard
RSIP at those times when all endpoints are transitioning.
RSIP Forced
<Disabled> Disable forced restart.
<Enabled> Enable forced restart.
MGCP Keep-Alive Timeout
Use this menu to configure a keep-alive timer that will cause the CMG to re-send RSIP restart
messages on expiration. When enabled, this countdown timer is reset every time an MGCP message
is received from the Call Agent. On expiration, the CMG will react by starting periodic transmission
of a wildcard RSIP restart MGCP message to each of the configured Call Agents until it is
acknowledged.
Enter 1-255 minutes, 0 to disable.
MGCP Type of Service
Range is 0 to FF hexadecimal.
LCO Codecs
<Disable> - The LCO CODEC list is ignored. The configured CODEC algorithm preference is used
to determine which CODECs are used for a call, and the initial priority ordering
<Enable> - The LCO CODEC list is used to determine which CODECs may be used for the call, and
determines the initial priority ordering of CODECs.
LCO Ptime
<Disable> - The LCO ptime is ignored. The configured CODEC ptime preference, as
defined in the set (router) voip ptime CLI command, is used instead to determine which
ptime is to be used for a call, for a particular CODEC.
<Enable> - The LCO ptime is used to determine which packetization times may be used for the call.
SDP Codec Ordering
<LCO Order> - The SDP CODEC priority order will follow the LCO settings.
<Rdesc Order> - The SDP CODEC priority order will follow the Remote Descriptor.