Carrier Access CMG Router - Manual (Page 230)

11-4 CMG Router - Release 2.7
Router Configuration
Basic VoIP Setup
Command Description
set local off Set the controller to use CLI commands
disconnect a:1 Disconnect all connections to the T1-1 on the
Controller (slot a)
disconnect 1 Disconnect all connections to the FXS card in slot 1
disconnect 2 Disconnect all connections to the FXS card in slot 2
disconnect 3 Disconnect all connections to the FXS card in slot 3
disconnect 6 Disconnect all connections to the router card in slot 6
set a:1 up Set the T1 on the controller up
set a:1 fdl none Disable FDL output messages on the DS1
set a:1 lbo 1 Sets the DS1 Line Build Out to 0-133 feet
set a:1 framing esf Sets the DS1 to Extended Superframe (ESF) framing
set a:1 id "CAC DS1# A:1" Sets the DS1 ID to "CAC DS1# A:1"
set a:1 linecode b8zs Sets the DS1 line coding to B8ZS.
set a:1 loopdetect on Enables the detection of CSU loop code on the DS1
set a:1:all type data Set the T1-1 of the Controller, Type to Data
set a:2 down Set the T1-2 as Out-of-Service
set clock1 a:1 Set primary master transmit clock source
set clock2 internal Set secondary clock source
set a:2 up Set the T1-2 as In-Service
connect a:1:1-24 6:1:1 Connect Data DS0s to the CMG card
connect 6:1:1:1-8 1:1-8 Connect CMG voice ports to FXS ports
connect 6:1:1:9-16 2:1-8 Connect CMG voice ports to FXS ports
connect 6:1:1:17-24 3:1-8 Connect CMG voice ports to FXS ports
set verification off Disable verification prompts