Carrier Access CMG Router - Manual (Page 245)

CMG Router - Release 2.7 11-19
Router Configuration
Back-to-Back with Multi-Link PPP
Denver Router in Slot 1
Command Description
set 1 default Set Router to default settings
disconnect a:1 Disconnect all connections to the T1 on the
Controller (slot a)
disconnect 1 Disconnect all connections to the router in slot 1
set clock1 a:1 Set primary master transmit clock source
set a:1:all type data Set the T1-1 of the Controller, Type to Data
connect a:1:all 1:1:1 Connect all of T1-1 to the Router that is in slot 1
connect a:2:all 1:1:2 Connect all of T1-1 to the Router that is in slot 1
rename 1 "LocalUnit" "Denver" Rename the Adit 600 from "LocalUnit" (default)
to "Denver" (LAN)
set 1:1:1-2 multilink group 1 Rename the Adit 600 from "LocalUnit" (default)
to "Boulder" (LAN)
rename 1 "RemoteUnit" "wan1" Rename WAN #1 from "RemoteUnit" (default) to
"wan1"
set 1:1 ip address 2.2.2.1
255.255.255.0 Set the ethernet IP address, in the conventional IP
address format. (Router LAN)
add 1 "wan1" static ip network
1.1.1.0 255.255.255.0 1 Adds a static IP network (route) to the WAN
interface
set 1 "wan1" trunk multilink
group 1 Set the WAN interface named "wan1" to be
mapped to trunk multilink group 1
reset 1 Reboot the router, to enable all configurations set