Mgcp interoperability menu fields – Carrier Access CMG Router User Manual
Page 72
3-34
CMG Router - Release 2.7
Profile Directory:Router Card Profile
MGCP
MGCP Interoperability Menu Fields
Version
<IETF 0.1> IETF MGCP version 0.1, as specified in an IETF MGCP Internet draft.
<IETF 1.0> IETF MGCP version 1.0, as specified in an IETF RFC 2795 (default).
<NCS> Packet Cable MGCP version NCS 1.0
Delay Alert
<Disabled> Allow ringing the terminating subscriber before remote SDP is received (default).
<Enabled> Delay ringing the terminating subscriber until remote SDP is received.
Hookswitch Reporting
<Always> Always report hookswitch events (default).
<On Request> Wait for a request from the call agent before reporting hookswitch events.
Default IETF Event Package
<DTMF> Will set the DTMF package the default.
<General> Will set the General package the default.
<Line> Will set the Line package the default.
PiggyBacking
<Disabled> Disallow sending of piggyback commands (default).
<Enabled> Allow sending of piggybacked commands.
Address Format
<Brackets> MGCP will place brackets around IP addresses (default).
<No Brackets> MGCP will not place brackets around IP addresses.
Dialstring Format
<Commas> Insert commas between digit events (default)
<No Commas> Do not insert commas between digit events.
SDP Mode
<Full> SDP section contain all mandatory lines (v, o, s, c, t, m)
<Minimal> SDP section contain only necessary lines (v, c, m) plus a. Which are the only lines really
used for setting VoIP media stream parameters.
Parse Mode
<Lenient> Do not return an error response in benign situations (default).
< Strict> Return an error response for all protocol errors or requests for unavailable functions.
<Verbose > Do not return an error response in benign situations, but log the event.