Equipment rack assembly and installation – Toa FS-970 SERIES User Manual
Page 11
11
6. EQUIPMENT RACK ASSEMBLY AND INSTALLATION
6.1. Poor Installation Locations
Avoid installing the rack in the following locations.
• Locations that may be exposed to fire, heat or direct sunlight (ambient temperature should be between 0°C
and 40°C).
• Locations that may be exposed to rainwater, steam or high humidity.
• Locations exposed to vibration.
• Locations offering limited space at the rear of the rack for inspection.
• Locations where particles of metal or dust accumulate, or near chemicals or oil.
• Locations near high-voltage equipment or equipment sensitive to electro-magnetic fields.
6.2. Rack Assembly
• Follow the instructions in the manual attached to the rack to assemble.
• When installing the rack components, lay the rack down face-up as shown in the figure to facilitate work and
ensure safety. (For component installation, refer to Component Installation on p. 18.)
• Install the Blower Unit BU-412 after rack assembly completion but before installing each rack component.
Note
Some components require their functions to be readjusted before they are installed in the rack. In such cases,
install the components after readjustment completion. (Refer to p. 15.)
Front
Ceiling