Securing the rack cr-412-6 to the floor – Toa FS-970 SERIES User Manual
Page 13
13
6.5. Securing the Rack CR-412-6 to the Floor
Four anchor bolt mounting holes (ø15 mm) are provided in the rack bottom surface to secure the rack to the
floor. Referring to the figure below, make holes in the floor, then secure the rack to the floor using four M10-
M12 anchor bolts.
Front
460
400
615
(115)
100
360
440
566
Anchor bolt mounting hole (ø15 mm, 4 places)
Cable entry opening
6.6. Securing the Rack to the Wall (for Prevention of the Fall)
A knock-out hole (ø6.5 mm) is provided on the rack top panel. Break this hole with a screwdriver, and secure
the rack to the wall by installing a bracket in the exposed hole. (Note the bracket is not supplied with the
system. Purchase it separately in the market.)
Washer
Knock-out hole
Nut
Bracket
M6 bolt
Anchor
Bolt
[Installation example]