Toa FS-970 SERIES - Manual (Page 14)

14
6.7. Rack Suspension using Eyebolts
Eyebolts for suspension can be mounted to the rack top panel.
• Purchase the following parts separately in the market.
Eyebolts M16 ............... 4 pieces
Nut M16 ....................... 4 pieces
Plain washer M16 ........ 4 pieces
Remove four rubber hole covers provided on the top panel, and install eyebolts (4 places) in the exposed
holes as shown in the figure.
Important: The maximum rack system weight for 4-point suspension is 300 kg.
Eyebolt
Plain washer
Nut
Remove this rubber hole cover.
Top panel of the CR-272,
CR-412 and CR-412-6
6.8. Fine Height Adjustment of the Installed Rack
When the rack installed on the floor is unstable and shaky, make fine adjustment of its height by turning
clockwise the height adjustment screw located in the front of the bottom rack base. Use the standard
screwdriver for adjustment.
6.9. Grounding
Provide grounding terminals using three grounding terminal screws (M5) located at the rear of the bottom rack
base. Three female screws (M5) are located in the front of the base. Use these screws as required.