YSI MultiLab 4010-2 - Manual (Page 101)

MultiLab 4010-2 Data storage
ba76142e03 08/2013 101
11 Data storage
You can transmit measured values (datasets) to the data storage:

Manual data storage (see section 11.1 M ANUAL DATA STORAGE , page 101)
 Automatic data storage at intervals (see section 11.2 A UTOMATIC DATA STO -
RAGE AT INTERVALS , page 101)
11.1 Manual data storage
You can transmit a measurement dataset to the data storage as follows. The
dataset is at the same time output to the interface:
If the storage is full When all storage locations are occupied, it is not possible to continue storing.
Then you can e.g. transmit the stored data to a PC or a USB flash drive (see
section 11.3.1 E
DITING THE MEASUREMENT DATA STORAGE , page 104) and sub-
sequently erase the storage (see section 11.3.2 E RASING THE MEASUREMENT
DATA STORAGE , page 105).
11.2 Automatic data storage at intervals
The storage interval (Interval) determines the time interval between automatic
data storage processes. Each data storage process transmits the current data-
set to the interface at the same time.
Configuring the
automatic storage
function
1. Press the <STO> key shortly.
The menu for manual data storage appears.
2. If necessary, change and confirm the ID number (1 ... 10000) with
<><> and <ENTER>.
The dataset is stored. The meter switches to the measured value dis-
play.
03.04.2013 11:24:16
pH 7.000 24.8 °C AR +++
ID number: 1
continue
Manual data storage 4 von 500
01.08.2013 08:00
1. Press the <STO_> key.
The menu for automatic data storage appears.