AEG 5210 V - Manual (Page 4)

Safety Instructions
For the
electrical
installer
To comply with safety regulations manufacturers have to draw
your attention to the following:
- According to the technical connection conditions of the elec­
tricity board serving your area, the appliance may only be
connected to the mains supply by an approved electrical
installer.
In the fixed connection, a device allowing the appliance to be
isolated on ail poles from the mains supply with a contact open­
ing width of at least 3 mm must be provided. Suitable isolating
devices are line protection switches, fuses (to be removed
from the holder), FI switches and contactors.
Please note that in the case of built-in furniture units the plastic
coating or the veneer must be applied with a heat resistant ad­
hesive (100 “C). It the plastic coating and the adhesive are not
heat resistant, it is possible for the coating to deform or be­
come detached, particularly along the edges of the built-in fur­
niture units.
In respect of fire protection, the appliance conforms to type Y
(lEC 335-2-6). Only appliances of this type may be installed on
one side of adjacent upright kitchen housings or walls.
The distance between a hob and fume extractor hood
must be ot the extent indicated in the instaiiation in­
structions of the fume extractor hood.
The plinth recess can be adjusted to line up with the furniture
plinth of most types of kitchens.