AMT Datasouth 41AY89AR777 User Manual
Page 110
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
This command is used to set bar code height. The height of the bar code is
determined by the most recent ''H command. The human readable portion of the
bar code is not included in the height value. The command sequence is as
follows:
"Hhh
The command sequence parameters are described below.
4.6.1 SET BAR CODE HEIGHT
'H
“Caret H” is the required two-character sequence. (Not Control H.)
hh
is used to set the bar code height (vertical dimension) in tenths of an
inch. Values for “hh” can range from 00 to 99. If 00 is specified, a
height value of 01 is used. The default value for bar code height is
0.5 inches. Note, the vertical tenth inch increment is only an
approximation and is actually 7/72 inch. Specifying a height value of
99 yields an actual dimension of 9.6 inches.
10 LPRINT
20 LPRINT •''BNB PRINTEB 0.1 INCH-'D*
30 '
40 '
50 LPRINT "'Hll*
60 LPRINT "'BNB PRINTED 1.1 INCHES*
70 END
Figure 4.15 Bar Code Height Samples
4-51