Denso BHT-6000 - Manual (Page 137)

122
4.1 System Errors
If some error occurs when the power is turned on or during program execution, one of
the following error messages will appear on the LCD.
System Program error
■ Problem
A System Program error has occurred.
■ Solution
Contact your nearest dealer.
Low battery indication
■ Problem
When the power is turned on or an application
program is initiated, the battery voltage level has
lowered.
If the battery output voltage level lowers dur-
ing program execution, the BHT-6000 beeps
five times (for 0.1 second per beep).
■ Solution
If the BHT-6000 is loaded with dry batteries, imme-
diately turn off the power and replace the batter-
ies.
If the BHT-6000 is loaded with the Ni-MH battery
cartridge, immediately turn off the power and then
replace or charge the battery cartridge. (For the
charging procedure, refer to Chapter 5, Section
5.5.)
NOTE
Replace the
batteries!
(When dry batteries are loaded)
****************
** No System! **
****************
(When the Ni-MH battery cartridge
is loaded)
Charge the
battery!