Denso BHT-6000 - Manual (Page 71)

56
[4.6-4] Setting the communications protocol type
PROTOCOL TYPE
1:BHT Protocol
2:BHT IrProtocol
Selecting the "4:PROTOCOL TYPE" on the SET COM
menu calls up the screen shown at left.
Reversed is the current setting.
1 BHT Protocol: Selects the BHT-protocol for
downloading or uploading
files in System Mode or for
the execution of XFILE state-
ment in BHT-BASIC 3.0.
This protocol should be se-
lected for file transmission
with Transfer Utility.
2 BHT IrProtocol: Selects the BHT-Ir protocol for
downloading or uploading
files in System Mode or for
the execution of XFILE state-
ment in BHT-BASIC 3.0.
This protocol should be se-
lected for file transmission
with Ir-Transfer Utility C.
Select a desired item by using the numerical keys
or F5 and F6 keys, and then press the ENT key.
To return to the SET COM menu, press the C key.
Selecting the "2:BHT IrProtocol" on the PROTO-
COL TYPE screen calls up the screen shown at left.
Enter the ID number of the BHT-6000 by using the
numerical keys, and then press the ENT key. If
you do not need to modify the current setting,
press the ENT key only.
An ID number should be five-digit decimal
character string. The setting range is from
00001 to 65535. If the entered value is less
than five digits, the ENT key does not
become operable.
If you make a wrong entry, press the BS key to
delete it and then enter the correct data.
To return to the SET COM menu, press the C key.
NOTE
SET ID
00001 >> _
SET ID
00001 >> 65535_