East Coast Supercharging Lysholm 2010+ Camaro Supercharger Kit - Manual (Page 100)

P/N: 4LGE020-010 v1.1, 2011-04-29
© 2011 Lysholm
All Rights Reserved, Intl. Copr. Secured
90
This supercharger has been factory pre‑filled with special
Lysholm synthetic lubricant. Oil does not need to be added
to a brand new unit; however a fluid level check should be
performed.
Prior to operating the supercharger on the vehicle and after
installation onto the vehicle:
Check the supercharger fluid level via the factory installed
dipstick located on the top of the supercharger case. Do not
operate the supercharger without it.
Fluid level checking procedure:
1. Ensure that the fiber sealing washer is located on the
dipstick base.
2. Thread the clean dipstick into the unit until it seats.
3. Once the dipstick has seated, remove the dipstick
from the unit. Fluid should register in the cross-
hatched area on the dipstick.
4. DO NOT OVERFILL!!! Drain excess fluid from the
unit if it is above the maximum level on the dipstick.
Check the supercharger fluid level using the dipstick (or sight
glass if equipped) at least every 5,000 miles.
The supercharger fluid must then be changed at least every
30,000 miles.
i. Drain the fluid, re‑fill the unit only with 5.4 oz. (6.7oz for
3.3L) of Lysholm supplied lubricating fluid.
ii. Confirm proper oil level using the dipstick. DO NOT
OVERFILL!!
WARNING: Use of any other fluid other than the special Lysholm lubricant will
void the warranty and may cause component failure.
LYSHOLM SuPERCHARGER INTERNAL LuBRICATION
FLuID CHECK