East Coast Supercharging Lysholm 2010+ Camaro Supercharger Kit - Manual (Page 93)

P/N: 4LGE020-010 v1.1, 2011-04-29
© 2011 Lysholm
All Rights Reserved, Intl. Copr. Secured
83
Fig. 11A
SELECT
ARROW KEYS
IMPORTANT! To ensure trouble-free programming of your vehicle’s computer:
• Make sure the vehicle's battery is sufficiently charged.
• Turn off all accessories and close doors to prevent unnecessary drain on the battery.
• Locate “exterior” fuse panel and remove Qty 1 INFO, Qty 1 RADIO and Qty 1RADIO AMP labeled fuses. (If applicable)
• Do not attempt to program your vehicle while a battery charger is connected
• Improper battery voltage will result in failure of the programming process.
• Do not disconnect the cable or turn off the ignition during programming.
A. Reconnect the battery if previously dis-
connected.
B. Locate the vehicle’s OBD2 connector
located under the dash on the driver
side of the vehicle. See fig 11B.
C. Attach the OBD2 connector from the
Flash tool that is provided in the kit to
the vehicle’s OBD2 port. Make sure
this connector is seated all the way in
the vehicle’s OBD2 port. You don’t
want this connector to disconnect dur-
ing programming or damage may
occur to the vehicle’s ECM. See fig
11C.
11. REFLASH COMPUTER
CANCEL
NOTE: • All vehicles equipped with On-star that have
aftermarket stereos will experience problems
with the ability to re-program the vehicle’s ECM.
It is necessary to disconnect the aftermarket ste-
reo from the factory wiring harness before con-
tinuing with the programming procedure.
• Do not disturb the cable or turn the ignition off
during this time. If the programming is disrupted,
the computer will not start or run your vehicle!
Fig 11B
Fig 11C
OBD2 CONNECTOR