East Coast Supercharging Lysholm 2010+ Camaro Supercharger Kit - Manual (Page 49)

P/N: 4LGE020-010 v1.1, 2011-04-29
© 2011 Lysholm
All Rights Reserved, Intl. Copr. Secured
39
A. Locate the water pump and attach to the
water pump bracket as shown. See fig 5A.
B. Using the supplied ¼-20 x .50” screws,
secure the water pump mount to the water
pump bracket. See fig 5B.
C. Mount the water pump to the driver side
frame rail using one (1) of the OEM screws
that was originally used to mount the OEM
windshield washer bottle.
D. Trim the ¾” hose coming from the bottom
port of the reservoir (that is mounted on the
passenger side) to connect with the water
pump inlet. Secure with a supplied nylon
ratchet clamp. See fig 5C.
E. Trim the hose from the bottom port of the
water cooler to the water pump outlet and
then secure with a nylon ratchet clamp.
5. WATER PUMP INSTALLATION
Fig 5B
Fig 5C
Fig 5A
SECURE WITH
FACTORY
HARDWARE
TRIM HOSES TO
LENGTH
SECURE WITH
CLAMPS
NOTE: Ensure that there are no pinched sections in the
hose attached to the inlet of the pump. Pump inlet
restrictions may cause significant reduction in
pump flow.
PUMP INLET
PUMP OUTLET